Electrical Connection; General Safety; Technical Specifications Fitting Dimensions - Atag OX9011M Bedienungsanleitung

This appliance may only be connected by a registered
installer.
This built-in oven has been designed for domestic use. Use it
only for the preparation of food.
electrical
connection
230 V AC – 50 Hz – 3,5 kW
You should always comply with national and local regulations
for the electrical connection. These stipulate, among other
things, that the appliance should be earthed.
The house mains to which the appliance is connected must
comply with the national and local regulations.
Connect the appliance to a wall socket which has been
installed in accordance with the regulations in force. The wall
socket and plug should be accessible at all times.
Warning: The appliance should always be earthed.
Wiring diagram: On the upper side of the appliance there is
a label with the wiring diagrams on it.
Attention: The connected load and the mains voltage
required are specified on the data plate.
The connection should be made in accordance with the
national and local regulations.
Fixed connection: If you wish to make a fixed connection, it
should be fitted with an multi-polar isolating switch with a
minimum contact separation of 3 mm.
Mains connection: Use a good quality connection cable for
the connection (for example, H 05 VV -F or equivalent.
Maintenance: When maintenance is carried out on it, the
oven should be disconnected from the power supply, either
by removing the plug from the socket or by removing the
fuse from the meter cupboard.
GB 20
general Technical specifications
safety fitting dimensions
Building in
Building under
Type of current: 230 V AC – 50 Hz – 3,5 kW
Dimensions (L x W x D): 895 x 480 x 546 mm
This appliance conplies with the applicable EC directives.
GB 21