Philips GC4400 series Bedienungsanleitung Seite 20

EnGlish
20
Problem
The iron
does not
produce any
steam.
The iron
does not
produce a
steam boost.
Water
droplets drip
onto the
fabric during
ironing.
Possible cause
There is not
enough water in
the water tank.
The steam control
is set to position 0.
The iron is not hot
enough and/or the
drip-stop function
has been activated.
You have used
the steam boost
function too often
within a very short
period.
The iron is not hot
enough.
You have not closed
the cap of the filling
opening properly.
Solution
Fill the water tank (see chapter
'Preparing for use', section 'Filling
the water tank').
Set the steam control to a
position between 1 and 6 (see
chapter 'Using the appliance',
section 'Steam ironing').
Set an ironing temperature that
is suitable for steam ironing ( 2
to MAX). Put the iron on its heel
and wait until the temperature
light has gone out before you
start ironing.
Continue ironing in horizontal
position and wait a while before
you use the steam boost function
again.
Set an ironing temperature at
which the steam boost function
can be used ( 3 to MAX). Put
the iron on its heel and wait until
the temperature light has gone
out before you use the steam
boost function.
Press the cap until you hear a
click.