Electrical Connection - ROBLIN Ice Cube Bedienungsanleitung

Fitting the Chimney and Fixing the Hood Canopy
• Insert the Upper chimney with the slots facing upwards if the
hood is to be installed in the recirculation version, or vice versa
with the slots facing downwards if it is to be installed in the
ducting version, and fix the top part to the Upper Chimney
Connector using the Screws 12c (2.9 x 9.5) provided.
Recirculation version
• Make sure that position of the Air Outlet Connector 15 corre-
sponds to the Chimney Grille.
• If this is not the case, remove the chimney and adjust the posi-
tion of the Air Outlet Connector 15; replace the elements as
described above.
Before fixing the Hood Canopy to the Frame:
• Open the suction panel by pulling it.
• Unfasten the panel from the hood canopy by sliding the fixing
pin lever provided.
• Remove the Grease filters from the Hood Canopy.
• Remove any Activated charcoal filters.
• Working from below, fix the Hood canopy to the Frame pro-
vided, using the 4 screws 12f provided.

ELECTRICAL CONNECTION

• Connect the Hood to the Mains Power Supply, inserting a
bipolar switch with a contact aperture of at least 3 mm.
• Open the Suction Panel and the grease filters, make sure that
the power cable is properly inserted into the Suction fan socket
• Hook up the Connectors.
• From the inside, open the Neon lamp wiring box 24 by unfas-
tening the Screws.
• Hook up the remaining free Connector to the one in the Neon
lamp wiring box, then close the cover and fit the box in the lo-
cation provided.
• For the Recirculation Version, fit the Activated Charcoal
Odour Filter.
• Replace the Grease Filters and the Suction Panel.
EN
12f
24
12e
12c
Neon
2
22
2