Light Replacement - ROBLIN Creatix 800 Bedienungsanleitung

The Activated Charcoal Filter is only present on the Hoods in Recirculation version, and has
the job of retaining smells in the flow of air that passes over it, until reaching saturation. This
cannot be washed or regenerated, and must be changed when the 24H led on the display starts
to flash, or at least once every 4 months. The Alarm signal, if it has been activated, only
appears when the Suction motor is turned on.
Activating the alarm signal
• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on
installation or at a later date.
• Turn the Lights and the Suction Motor off.
• Press button E (Intensive) until confirmation is given:
• Motor Off Leds flash twice – Activated Charcoal Filter saturation alarm ACTIVATED.
• Motor Off Leds flash once – Activated Charcoal Filter saturation alarm DEACTIVATED.
CHANGING THE ACTIVATED CHARCOAL FILTER
Resetting the alarm signal
• Turn the Lights and the Suction Motor off.
• Press and hold button F (24H) for 2 seconds.
Changing the Filter
• Remove the Metal grease filters.
• Remove the saturated Activated charcoal filter, using the hooks
provided.
• Fit the new Filter, hooking it into place.
• Replace the Metal grease filters.
14 W neon light.
• Remove the metal terminals T fixing the glass cover or the
metal panel.
• Slide the glass cover or the metal panel to the right until the
left hand is free. Loweer it slightly and slide it to the left to free
it completely.
• Replace the light with a new one of the same type and rating.
• Replace the glass cover or the metal panel in reverse order.
EN
Activated Charcoal Filter (Recirculation Version)
Lighting

LIGHT REPLACEMENT

T
2 22