Getting Started - AEG QUICKSTEAM DBS3350 Anleitung

Getting started

1. Before first use. Remove all adhesive
GB
remains and gently rub with a
dampened cloth. Position the steam
generator iron horizontally on the
ironing-board or on a heat resistant,
secure surface at the same height
as an ironing-board. unwind and
straighten the power cord and the
steam cord. When turned on for the
first time, temporary vapours/odours
may occur.
4. Connect the steam generator iron
to the mains supply. Press the power
button (a). turn the temperature
selector clockwise to maximum
setting (B). the temperature indicator
light on the iron will illuminate. then,
select a steam level on the control
panel, from low - medium - high
steam.
26
A
2. Remove the water tank by gripping
the slot on the underside and pulling
it gently away from the base unit (a).
Detach the anti-calc cartridge and
then immerse it in water for more
than one minute (B). insert the anti-
calc catridge back. Fill the water tank
using cold water. it is recommended
to use destilled water or a mix of 50%
destilled, 50% tap water. Empty the
water tank to rinse out any foreign
particles which may remain from the
manufacturing process.
B
A
5. When the temperature indicator light
turns on, the steam station is pre-
heating. When the light turns off, it is
ready to be used. Press and hold the
steam button for about one minute
to get steam. then hold one more
minute in order to clean the steam
generating system.
B
A
B
3. Always refill the water tank to MaX
level using cold water. (a). insert the
water tank into the base unit (B).
it is recommended to use destilled
water or a mix of 50% destilled, 50%
tap water. Ensure that the water tank
latches securely into place.
6. Iron an old towel, to ensure that
any residues inside the iron are not
transferred to the laundry.
if necessary, wipe the sole plate with a
slightly damp cloth.