Getting Started - AEG 5SAFETY DB 80-Serie Anleitung

Getting started

1. Before fi rst use. Remove all adhesive
GB
remains and gently rub with a
dampened cloth. Rinse water tank
to remove foreign particles. When
turned on for the fi rst time, temporary
vapours/odours may occur.
auto
clean
4. Using the steam function
(for models without auto steam).
Turn the steam knob to select the
desired steam output for each
garment, if selecting the off position,
it indicates ironing without steam, the
iron can be used as a dry-iron.
AEG IFU 5Safety Mahe 19.07.11.indd 17
2. Filling steam iron with water.
Make sure plug is removed from
power outlet. Turn steam selector to
Dry setting and open fi lling aperture
cover. Using beaker provided, pour
water up to maximum level. Close
cover.
5. For models with auto steam control
system the steam regulation is done
by the temperature selector. When
turning it to set temperature, it will
automatically adjust steam position,
as indicated on the knob. To stop the
steam and use as a dry-iron, press
down . To come back to steam
function, press again.
3. Plug power cable into a power
outlet. Power indicator light turns
on. Set temperature by turning
temperature selector to adequate
choice. When the light turns off , iron is
ready to be used.
A
6. Using the spray mist and steam
jet function. Ensure that water tank
is at least 1/4 full. Use spray mist to
pre-dampen fabrics by pressing spray
button several times to release a fi ne
mist (A). To use the steam jet function,
ensure that tank is at least 1/2 full.
Press steam jet button several times to
prime pump (B).
D
EL
NL
F
GB
B
17
19.07.11 11:19