FLEISCHMANN 413613 Bedienungsanleitung Seite 18

re-set the equipment to 14 steps, or re-program the LokSound decoder to
28 steps (see CV29 in chapter 5).
2. The loco sound is not clear:
Run the loco in pure DCC- or Motorola*-operation.
3. The loco does not respond to Motorola* commands:
If the decoder is set to handle the long DCC-address, then you must change the
setting to use the short address (CV29, bit5 = 0).
5. LIST OF THE IMPORTANT CV's
CV Name Basic Description
Value
1 Loco address accor- Defines the digital Address for DCC (3)
ding
to the dress of the loco decoder
loco
2 Start-up current accor- This CV sets the motor current to speed
ding
to the the motor characteristic table
loco
3 Acceleration accor- Inertia values when accelerating
inertia ding
to the
loco
4 Braking inertia accor- Inertia values when braking
ding
to the
loco
5 Maximum accor-
current ding
to the
loco
10
and Motorola* (78/72/24/60) 1-Byte ad-
level 1, if not set by CV 29 Bit 4 as in
This CV sets the running current to the
highest speed level. Possible maximum
is 63. See also CV2.
6 Middle accor- Running current setting for the middle
current ding
to the switch the middle areas off. The motor
loco
8 Manufacturer 151
Identification
17 Long 192
Addresses
(upper section)
18 Long 0
addresses
29 Configuration Bit 0=0 Bit 0: With Bit 0 = 1 the direction of the
values
Bit 1=1 1: basic value 1 is valid for run ning the
Bit 2=1 Bit 2: With Bit 2 the recognition of
area speed steps. A value of 0 will
control characteristics will be linearly
calculated by CV2 to CV5. By using
this CV it is possible to seta non-linear
control characteristic.
NMRA identification number for the ESU
makers. By programming this CV with
the value 8 will re-set to the works
setting. Warning: the TWIN-CENTER
will always indicate an error.
Upper section of long addresses.
Effective on DCC with CV29 Bit 5 = 1.
When programming a long address with
the TWIN-CENTER, CVs 17, 18 and 29
are automatically set.
Lower section of long addresses.
Effective on DCC with CV29 Bit 5 = 1.
vehicle will be reversed.
decoder with 28/55 or likewise 128
speed steps. If the decoder is to be run
using 14/27 steps, then Bit 1 = 0 should
be set. The desired steps can be set
using the equipment.
analog power is switched on. With
Bit 2 = 0 pure digital operation is valid.
For operation layouts with mixed multi-
train languages, i.e. with TWIN-CEN-
TER, pure DCC must be switched on.