MADRIX NEBULA Kurzanleitung & Technisches Handbuch Seite 18

Using The MADRIX
You can connect MADRIX
of the computer that runs the MADRIX
device over network cabling and sent to the output ports (Port 1 and Port 2).
Follow these quick steps to configure Art-Net in the MADRIX
Step 1) Put MADRIX
supplying power, and setting the output protocol; as described above.
Step 2) Connect NEBULA to your computer using Ethernet network cabling.
Step 3) Assign correct network settings for your PC in the Windows operating
system. (Recommended default settings:
IP address 10.0.0.1 / Subnet mask 255.0.0.0)
Step 4) Start the MADRIX
Manager...' à tab 'Art-Net' and activate 'Enable'. Click on the
search button (loupe icon) and the device appears in the list.
Step 5) Go to 'Preferences...' à 'Device Manager...' à tab 'DMX Devices'
to configure the output. Activate 'Enable' for each required output
port in the section 'Settings'.
Step 6) Configure
à 'Matrix Generator...' or à 'Patch Editor...'.
For more information, please read the MADRIX
How To Update The Firmware
It is highly recommended to update the firmware of MADRIX
new firmware version become available. You can do so in different ways. Follow
these quick steps to update the firmware in the MADRIX
Step 1) Connect MADRIX
Step 2) Start the MADRIX
Step 3) In the MADRIX
Configuration...'. A new window will open. Click on the search button
(loupe icon) and the software will search for connected devices.
Select your device in the list, click on the 'Firmware' button, and
follow any instructions.
For more information, please read the MADRIX
17
EN
Software And Art-Net
®
NEBULA over Ethernet network to the network card
®
NEBULA into operation by connecting the LEDs,
®
Software and go to 'Preferences...' à 'Device
®
your virtual
NEBULA to your computer over USB.
®
Software.
®
Software, go to 'Tools...' à 'MADRIX Device
®
Software. Data is distributed to the
®
LED matrix using
user manual.
®
user manual.
®
Software:
®
'Preferences...'
NEBULA should a
®
Software over USB:
®