MADRIX NEBULA Kurzanleitung & Technisches Handbuch Seite 15

3) Configuration (Setting The Output Protocol)
You can access and change specific device settings, including the SPI protocol,
the IP address, and the number of channels sent per universe, in different ways.
Please note: In order to put MADRIX
set the correct output protocol according to the LEDs you have connected.
Web Configuration Through A Web Browser
Step 1) Connect MADRIX
Step 2) Assign correct network settings in the Windows operating system.
(Recommended: IP address 10.0.0.1 / Subnet mask 255.0.0.0)
Step 3) Open your web browser and enter the IP address of MADRIX
(You can find the default IP address on the side of the NEBULA device.)
Step 4) The built-in web configuration tool will be launched. Go to
'Output Settings' à 'Output Protocol' and choose the LEDs your are
using for 'Port 1' and 'Port 2'. Apply changes with 'Set'.
Step 5) Change any other settings as required. Apply changes with 'Set'.
MADRIX Device Configuration In MADRIX
Step 1) Connect MADRIX
Step 2a) For the USB connection, Microsoft
interface drivers automatically. When ready, the status LED for
USB will fade between red and green; as described on page 15. Start
the MADRIX
à 'Options...' à tab 'Devices USB'. Activate 'MADRIX NEBULA' and
click 'OK'. (The driver is activated by default.)
Step 2b) For the Ethernet connection, enable network drivers in MADRIX
Go to 'Preferences' à 'Options...' à tab 'Devices Network'.
Activate 'Enable LUNA / NEBULA / PLEXUS / STELLA' and click 'OK'.
(The driver is activated by default.)
Step 3) In MADRIX
new window will open. Click on the search button (loupe
icon) and it will search for connected devices. Select your device in
the list and click on the configuration button (gear wheel icon).
Step 4) Go to 'Port Output Settings' and choose the LEDs your are using for
'Port 1' and 'Port 2'. Apply changes with 'Set'.
Step 5) Change any other settings as required. Apply changes with 'Set'.
NEBULA and your computer to the same network.
®
NEBULA to your computer via USB or via Ethernet.
®
Software and enable USB drivers. Go to 'Preferences'
®
, go to 'Tools...' à 'MADRIX Device Configuration...'. A
®
NEBULA fully into operation, please
®
®
Windows
®
NEBULA.
®
will install the
®
.
®
14
EN