Herunterladen Inhalt Inhalt Diese Seite drucken

MADRIX NEBULA Kurzanleitung & Technisches Handbuch Seite 17

Vorschau ausblenden Andere Handbücher für NEBULA:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

How To Install On DIN-Rails
Unmounting (Pictured Right)
Step 1) Pull the unlocking clip.
Step 2) Lift the lower part of the device from the
rail in an angle.
Step 3) Lift the device from the rail.
Using The MADRIX
You can connect MADRIX
runs the MADRIX
®
cabling and sent to the output ports (Port 1 and Port 2):
Step 1) Put MADRIX
supplying power, and setting the output protocol; as described above.
Step 2) Connect MADRIX
using the provided USB cable.
Step 3) Enable USB drivers in MADRIX
à tab 'Devices USB'. Activate 'MADRIX NEBULA' and click 'OK'.
Step 4) Configure the output. Go to 'Preferences...' à 'Device Manager...'
à tab 'DMX Devices'. Activate 'Enable' for each required output port.
Step 5) Configure
à 'Matrix Generator...' or à 'Patch Editor...'.
For more information, please read the MADRIX
Mounting (Pictured Left)
Step 1) Hook the device in an angle onto the upper
edge of the rail.
Step 2) Pull the unlocking clip.
Step 3) Press the lower part of the device against
the rail and let the clip snap into position.
Software And USB
®
NEBULA directly over USB to the computer that
®
Software. Data is distributed to MADRIX
NEBULA into operation by connecting the LEDs,
®
NEBULA to a free USB 2.0 port of your computer
®
your
virtual
. Go to 'Preferences...' à 'Options...'
®
LED
matrix
using
user manual.
®
NEBULA via USB
®
'Preferences...'
16
EN

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Nebula

Inhaltsverzeichnis