Sharp XG-P20XU Bedienungsanleitung Seite 33

No. Adjusting point
25 Color system 1. Receive the color bar sig-
performance
check
26 Video system 1. Receive the monoscope
performance
check
27 Audio system
performance
check
28 RGB 1. Receive the RGB signal.
performance
check
29 Off-timer
performance
check
30 Thermistor 1. Heat the thermistor using a
performance
check
31 Automatic 1. Receive the PHASE check
synchronization
32 Keystone
correction
performance
check
33 Factory settings
Adjusting conditions
nal.
pattern signal.
dryer.
pattern signal.
33
http://www.pureglare.com.au
Adjusting procedure
» In the process mode and select L1. Check the color
and tint.
» In the process mode and select L2. Check the pic-
ture, brightness and sharpness.
» In the process mode nad select L3. Check the bass,
treble and balance.
» In the process mode and select L4. Check the pic-
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.
» In the process mode and select OFF. Make sure that
the off-timer starts with "5" (minutes), counts down
each minute in 1 second, and turns off the set at "0".
» Make sure the "TEMP" is displayed.
» Call the VGA/S-VGA/XGA mode and make sure
that the clock, phase, horizontal and vertical
positions can be automatically adjusted.
» Make sure the keystone correction functions well.
» Make the following settings.
Remote controller setting
Process
adjustment
S4 "Factory setting 4" for XU
S3 "Factory setting 3" for XE/XD
XG-P20XU
XG-P20XE
XG-P20XD