Resetting The Total Lamp Timer - Sharp XG-P20XU Bedienungsanleitung

Resetting the TOTAL LAMP TIMER

Resetting the lamp timer
1
Connect the power
cord.
Plug the power cord into the AC
socket of the projector.
•Reset the lamp timer only after replacing the lamp.
• As the usage environment can vary significantly, the projector lamp may not operate for 1,500 hours.
Maintenance Indicator Condition
TEMPERATURE The internal
WARNING indicator temperature is
abnormally high.
LAMP REPLACE- The lamp does
MENT indicator not light up.
POWER indicator The POWER
indicator flashes
in red when the
projector is on.
2
Reset the lamp timer.
While pressing ",| and
ENTER on the projector,press
POWER ON on the projector.
ON
Problem
· Blocked air intake.
· Clogged air filter.
· Cooling fan breakdown.
· Internal circuit failure.
· Burnt-out lamp.
· Lamp circuit failure.
· The bottom filter cover is
open.
19
http://www.pureglare.com.au
"LAMP 0000H " is displayed,
indicating that the lamp timer is
reset.
LAMP 0000H
Possible Solution
· Relocate the projector to an area with
proper ventilation.
· Clean the filter.
· Take the projector to your nearest Au-
thorized Sharp Industrial LCD Products
Dealer or Service Center for repair.
· Carefully replace the lamp.
· Take the projector to your nearest Au-
thorized Sharp Industrial LCD Products
Dealer or Service Center for repair.
· Securely install the bottom filter cover.
XG-P20XU
XG-P20XE
XG-P20XD