Warning - Batteries; Installation - Hama EWS-890 Bedienungsanleitung

Warning – Batteries
• Immediately remove and dispose of dead batteries from
the product.
• Only use batteries (or rechargeable batteries) that match
the specified type.
• Do not mix old and new batteries or batteries of a different
type or make.
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly. Failure to do
so could result in the batteries leaking or exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries and
keep them away from uncoated metal objects.
4. Getting Started
4.1. Measuring station
• Remove the screen protector from the display.
• Open the battery compartment (26) and insert two AA batteries
with the correct polarity.
• Move the CH slide switch (25) to the left or right to select the
channel on which the measuring station transmits. (22) CH1,
CH2 or CH3 is displayed. Once the channel has been assigned
to a transmitter, it can only be changed by removing the
batteries or by resetting the base station (see section 6.9 Reset).
• The measured temperature and humidity values are displayed in
alternating fashion.
• Close the battery compartment cover.
• Close the battery compartment.
Note
Before use, ensure you insert the batteries in the measuring
station first and then in the base station.
4.2. Base station
• Remove the screen protector from the display.
• Open the battery compartment (20) and insert two AA batteries
with the correct polarity.
• Close the battery compartment.

5. Installation

Note – Installation
• We recommend initially placing the base and measuring
stations in the intended locations without installing them
and making all the settings described in
6. Operation – to do.
• Only install the stations once the appropriate settings have
been made and a stable wireless connection is established.
Note
• The wireless transmission range between the measuring
and base stations is up to 50 m in open spaces.
• Before installation, ensure that wireless transmission will
not be disrupted by interference or obstacles like buildings,
trees, vehicles, high-voltage lines, etc.
• Before the final installation, ensure that there is sufficient
reception between the intended installation locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage
the product.
• Before installation, ensure that the chosen wall is suitable
for the weight to be mounted, and make sure that there
are no electrical wires, water, gas or other lines at the
installation site on the wall.
5.1. Base station
• Use the base to position the base station on a level surface.
5.2. Measuring station
• You can also position the measuring station on a level outdoor
surface.
• We recommend installing the measuring station securely on an
outdoor wall using the opening (23).
• Install an anchor, screw, nail, etc. in the wall of your choice.
• Hang the measuring station using the opening intended for this
purpose (23).
3