A Base Station - Hama EWS-890 Bedienungsanleitung

G Operating instruction
Controls and Displays

A Base station

1. Time
2. Room temperature
3. Room humidity
4. Alarm symbol
5. Radio symbol
6. Weather forecast symbol
7. Measuring station radio symbol
8. Outdoor temperature
9. Outdoor humidity
10. Channel display
11. SNOOZE/LIGHT button
= stops the alarm/activates the backlight (approx. 5 seconds)
12. ALARM SET button
= display/set alarm mode
13. CH+ button
= channel selection/increase the current set value
14. °C/°F selector slide switch
= switches between °C and °F
15. SENSOR button
= manual search for a signal from the measuring station
16. DISPLAY SET button
= settings/confirms the setting
17. MEM– button
= recalls the saved maximum/minimum values / decrease the
current set value
18. RESET button
= restores factory settings
19. RCC button
= activate/deactivate manual radio signal reception
20. Battery compartment
B Measuring station
21. Transmission indicator lamp
22. Display
23. Recess for wall mounting
24. RESET button
= restores factory settings
25. CH slide switch
= channel selection
26. Battery compartment
Thank you for choosing a Hama product.
Take your time and read the following instructions and information
completely. Please keep these instructions in a safe place for
future reference. If you sell the device, please pass these operating
instructions on to the new owner.
2
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw
your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package Contents
• EWS-890 weather station
(base station for indoors/measuring station for outdoors)
• 4 AA batteries
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial use only.
• Do not operate the product outside the power limits given in
the specifications.
• Do not use the product in moist environments and avoid
splashes.
• Do not use the product in the immediate vicinity of heaters or
other heat sources or in direct sunlight.
• Do not use the product in areas where the use of electronic
devices is not permitted.
• Only connect the product to a socket that has been approved
for the device. The socket must be installed close to the product
and easily accessible.
• Do not drop the product and do not expose it to any major
shocks.
• Do not open the device or continue to operate it if it becomes
damaged.
• Do not attempt to service or repair the product yourself. Leave
any and all service work to qualified experts.
• Keep the packaging material out of the reach of children due to
the risk of suffocation.
• Dispose of packaging material immediately according to locally
applicable regulations.
• Do not modify the product in any way. Doing so voids the
warranty.