Troubleshooting - EINHELL STE 2500/1 Bedienungsanleitung

Anleitung STE 2500-1 SPK7:Anleitung STE 3500 SPK1
GB

15. Troubleshooting

Fault
Engine does not start
Generator has too little or no
voltage
10
18.06.2007
Cause
Automatic oil cut-out has not res-
ponded
No fuel
Controller or capacitor defective
Overcurrent circuit-breaker has
triggered
Air filter dirty
9:28 Uhr Seite 10
Remedy
Check the oil level, top up with
engine oil
Refuel
Contact your dealer
Actuate the circuit-breaker and
reduce the consumers
Clean or replace the filter