Maintenance; Dismantling And Disposal Of The Transfer Press - SISER TS-MONO Gebrauchsanweisung

TS
MONO

8 MAINTENANCE

8
Following the safety directions mentioned below is essential to avoid severe injuries to the
operator and / or damage to the transfer press.
EN
Before performing any maintenance work, the transfer press must have been switched off and
the plug must have been removed from the power socket.
Note the high temperatures of the heating plate (top). It can take up to 15 minutes until the
plate has cooled down to a temperature below 50° C.
Carefully follow the instructions mentioned in this manual before performing any maintenance
or cleaning work on the transfer press.
Maintenance work must only be performed by skilled and specially trained staff.
Before switching on the unit again after maintenance or cleaning work, ensure that no tools
or spare parts have been left in or on the unit and that shrouds, safety appliances, graphic
symbols and instructions attached to the press are in good condition and easy to read.
9

9 DISMANTLING AND DISPOSAL OF THE TRANSFER PRESS

All work for dismantling or disposal must be performed by sufficiently qualified staff.
A transfer press is an industrial unit. All applicable laws concerning the disposal of industrial
machinery in the country of the user must be followed.
Disconnect the unit from the power supply and dismantle it. Sort the parts according to their
composition, e.g. aluminium, plastic, steel, mineral wool etc. The disposal of these material
groups must be performed in accordance to the applicable laws in the country of the user.
Strictly follow the safety instructions mentioned in this manual when dismantling the press.
26
TS-MONO Manual for use and maintenance
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 02/2018