Herunterladen Inhalt Inhalt Diese Seite drucken

SISER TS-MONO Gebrauchsanweisung Seite 23

Transferpresse mit austauschbaren platten
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Fitting and Connecting the Cap Set
Before fitting the cap set ensure that the unit is cold and switched off. Then unplug the cable
between heating plate and instrument box.
Now untighten the clamping element of the heating plate suspension, remove the heating plate
with care and put it down on a safe, even surface.
Fit the bent heating cap plate in place of the normal heating plate and tighten it to the
suspension using the clamping element.
Then connect the heating element to the instrument box by plugging in the connector into the
socket.
The heating element is now ready for use.
After that install the bent supporting cap plates observing the following instructions:
To exchange the flat supporting plates with bent cap supporting plates untighten the two fixing
screws just underneath the supporting plates, remove the flat plates and fit the bent cap plates
in the same way. Please do not forget to tighten the plates again.
Fitting the Plate Sets
For fitting the various supporting plates untighten the two fixing screws just underneath the
supporting plates. Now you can swap the present supporting plate for a plate of your choice
and fix the new plate by tightening the fixing screws.
It is not necessary to swap the heating plate, even if the heating plate sticks out in case of
smaller supporting plates. However you should never use the bent supporting cap plate
together with a flat heating plate for t-shirts.
TS MONO
con piastre intercambiali
cm. 15x15
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
fig. b - Plate set for sleeves, trousers and
pockets.i
TS MONO
con piastre intercambiali
cm. 15x38
TS-MONO Manual for use and maintenance
Mod. PRD 20/3 - Last updating 02/2018
TS MONO
con accessorio cappellini
TS
MONO
6
EN
23

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für SISER TS-MONO

Inhaltsverzeichnis