SISER TS-MONO Gebrauchsanweisung Seite 16

Reproduction, memorization and transmission
of all and parts of this publication are
prohibited in any form without the prior written
authorization and consent of SISER S.r.l..
SISER S.r.l.,with its policy of constant
improvement and development of its products,
reserves the right to alter the specifications,
equipment and instructions for use and
maintenance at any time and without notice.
Thank you very much for buying one of our Siser TS MONO heat transfer presses.
We are sure you will capitalise on this excellent unit for years if you take the time to read these
instructions carefully.
Introduction
Please study these instructions carefully before transporting, mounting, using or maintaining
the transfer press, as they will give you important directions for a safe handling. Moreover you
will find information about how to order spare parts in this manual.
Please retain these instructions for later reference in a safe, easily accessible place.
Please make sure that all operators of the transfer press have understood all instructions and
graphic symbols labelled on the press.
The TS-MONO machine is equipped with electrical parts operating at a voltage ranging between
50 V and 1000 V and is subject to the Low Voltage Directive 2014/35/UE
(formerly 2006/95/CE ) and the Electromagnetic Compatibility Directive 2004/108/CEE.
Since closing and opening of the plates are regulated mechanically, the
Machinery Directive 2006/42/CE applies to the TS-MONO.
According to this, the design and the construction of this machine have been
made in compliance with the essential safety requisites foreseen by Directive
2006/42/CE.
It is specifically prohibited to remove or manipulate shrouds or legally compulsory labels
or plates.
16 This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
TS-MONO Manual for use and maintenance
Mod. PRD 20/3 - Last updating 02/2018