SISER TS-MONO Gebrauchsanweisung Seite 25

When the flashing has stopped, set the desired temperature in Celsius on the electronic display:
"+" rises the temperature, "-" lowers the temperature. When the desired temperature is
reached, confirm by pressing the "S" button.
2. After that you have to set the desired pressing time in seconds: "+" extends the time, "-"
reduces the time. If the switch is pressed a second time, the data is saved and the temperature
set before is shown again on the display. The heat transfer press is ready for use as soon as
the desired temperature is reached.
It is always possible to check time and temperature by tapping the "S" button.
Working programms
With the new control board TS2 3P 4 different programs may be saved: the standard program
in addition to 3 new programs dedicated to Flock, Flex or Sublimation transfers. Thanks to this
new system you only need to enter the right parameters in order to transfer quickly.
Parameter adjustment
Standard-program (00)
Please press the button S for 25/30 seconds. The display confirms the access to the program
by showing 00 followed by a flashing and audible signal.
In order to modify the program, please press again the button S for 25/30 seconds.
Flex-Program (01)
• Press button S
• he display shows up 01, followed by the audible signal and blinking
• On the display the preset parameters appear: 160°C and 15 seconds
Flock-Program (02)
• Press button S
• The display shows up 02, followed by the audible signal and blinking
• On the display the preset parameters appear: 150°C and 15 seconds
Sublimation-program (03)
• Press button S
• The display shows up 03, followed by the audible signal and blinking
• On the display the preset parameters appear: 200°C and 60 seconds
The operator may change the preset parameters with buttons "+" and "-".
The modified parameters may be saved directly by pressing button S and may
always be recalled and altered again.
The preset temperature may be modified in each program (01...02...03) plus or
minus 20 °C.
For the standard program however, temperatures between 0°C and 250° may be adjusted.
Display signals
In case of failures, the new control board TS2 3P gives different signals in order to
discover and resolve the problem immediately.
• If 111 appears on the display and the light blinks, followed by an acoustic
signal, the temperature sensor is defect or not connected with the control board.
• If 000 appears on the display and the light blinks, followed by an acoustic
signal, the temperature ranges about 15°C because of a default. The control board has to be
checked.
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
TS-MONO Manual for use and maintenance
Mod. PRD 20/3 - Last updating 02/2018
TS
MONO
7
EN
25