Directions For Use - SISER TS-MONO Gebrauchsanweisung

TS
MONO

7 DIRECTIONS FOR USE

7
Please note the risks involved in using a transfer press mentioned in paragraph 4 of this
manual, in particular
• the risk of squashing your hands in between the plates
EN
• the risk of an electric shock
• the risk of burning your hands and arms on the heating plates
Wear protective gloves to avoid the risk of getting burned.
Implementing the Transfer Press
1) Plug the connector cable into a power socket of 220 V.
2) Open the air tap for the filter controller upwards.
3) Set the master switch from 0 to 1.
4) Check the connection between heating plate and control unit. Is the 6 pole connector
securely plugged into the socket of the control unit?
5) Set the desired temperature.
6) Set the desired pressing time on the timer.
7) Adjust the incoming pressure at the instrument on the upper left side of the press.
The printing pressure is shown on the manometer and can be adjusted using the pressure
controller.
To adjust the pressure, pull the pressure controller outwards and turn it
- clockwise to increase the pressure
- anti-clockwise to reduce the pressure
After you have set the pressure, push the controller back into its original position.
8) Adjust the "real" printing pressure by turning the pressure controller on the right upper side
of the press. To adjust the pressure turn it
- clockwise to increase the pressure
- anti-clockwise to reduce the pressure
9) Place the textile to be printed on the lower plate and position the plotted transfer onto it.
Swivel the upper heating plate above the prepared lower supporting plate using the handles
fixed to the side of the heating plate.
10) Press the two push buttons located on both sides of the pressure arm simultaneously. The
heating plate will descend and after the pressing time has elapsed, it will be lifted automatically
in its original position. The press is now ready for a new transfer process.
11) A new feature of TS MONO is the yellow stop-button in front of the heat press, which allows
a stop of the pressing-process at any time. This can be used for any pre- or post-pressure
situation. Just push the button to stop the pressing-process.
12) Switch off the transfer press when you do not use it.
WE HIGHLY RECOMMEND NOT TO TOUCH THE AIR FLOW CONTROLLER IN THE FILTER GROUP!
Operating Parameters
Please set the operating parameters (time and temperature) by using the display and the LEDs
on the control panel.
Annotations
1. After you have pressed the "S" button (SET), "01" starts flashing on the display.
24
TS-MONO Manual for use and maintenance
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 02/2018