SISER TS-MONO Gebrauchsanweisung Seite 21

Before operating the transfer press, the operator must have fully understood the handling and
function of the electric components of this transfer press and must have read and grasped all
information provided in this manual.
NOTE: There is the risk of getting burned if you touch the heating plates during operation.
We strongly advise the operator to wear protective gloves providing protection up to a
temperature of 250° C.
Avoid to touch the heating plates of the transfer press during operation and for a period of 15
minutes after the press has been switched off, as the operating temperature of the press is
very high. Please also avoid to touch the lower supporting plates when closing the press or
printing the textile, as these operations involve a risk of getting squashed and burned.
It is strongly recommended that only one person operates the transfer press.
Any kind of maintenance and / or repair work on the transfer press must only be performed
after the heating plate has been switched off and has cooled down to ambient temperature.
Do not use the transfer press in a humid or wet environment. Before swapping the heating
plates, switch off the unit and allow it to cool down to ambient temperature.
To not perform any transfers to textiles containing solvents, flammable liquids, gaseous or
liquid fuels.
Unauthorised changes of the unit or the replacement of parts without consent of Siser srl are
prohibited.
Siser srl is not liable for damages, losses, injuries or consequential damages resulting from
acts, changes or other use of the transfer press not authorised by a prior written consent from
Siser srl.
All mounting, maintenance and repair work must be performed only by skilled and specially
trained electricians.
It is strictly prohibited to remove or manipulate any kind of safety appliances.
The working area must be clean, tidy and free of any obstacles for manoeuvring the heat
transfer press.
All general instructions for operation and all safety instructions must be strictly followed
to avoid any injuries that might result from the use of this transfer press and to ensure a
successful utilisation of the press.
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Identification of the machine
The press is fitted with an identification plate containing
the serial number, positioned on the machine body
TS-MONO Manual for use and maintenance
Mod. PRD 20/3 - Last updating 02/2018
TS
MONO
3
EN
21