Safety; Hazards And Safety Measures - SISER TS-MONO Gebrauchsanweisung

TS
MONO

3 SAFETY

3

3.1 Hazards and Safety Measures

The main hazards connected with the use of the machine are listed in the table below, with the
EN
safety measures to apply.
Symbol
Burns
Fire
Crushing hands
Electro-caution
20
Explanation of Symbol
Physical contact with
the platen
Contact of the platen
with flammable
materials
Closure of the platen
Contact with parts
connected to power
source
TS-MONO Manual for use and maintenance
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 02/2018
Safety Measures
Switch off the machine and wait 2 hours before
changing or touching the platen.
Do not check the temperature of the platen
with your bare hands.
Wear heat-resistant gloves.
Do not heat apply transfers to flammable
materials or fabrics that have been in
contact with solvents, flammable liquids or
combustible liquids or gas.
Do not leave flammable or combustible
materials near the machine.
Keep your free hand away from the plate during
closure to prevent possible crushing.
Do not allow more than one person to work on
the machine.
Make sure the power source supplies adequate
voltage as listed on the rating plate of the
machine.
Periodically check the conditions of the power
cord and replace it if necessary.
Protect the cord and power panel from
moisture.
Unplug the machine before performing any
maintenance.
Authorize only expert personnel to work on
electrical parts.