Description - Facom DX.T10 Bedienungsanleitung

3. DESCRIPTION

➀
Infrared measurement lens.
➁
Laser pointer orifi ce.
➂
K-type thermocouple sensor base.
➃
Backlit liquid crystal display :
- Main display : numerical temperature value (±) 3½
digits or OL error code
- Symbols :
K K-type thermocouple sensor.
Battery discharged.
HOLD Last value measured.
°C/°F Unit of temperature displayed.
MAX Maximum value of temperature measured.
MIN Minimum value of temperature measured.
SET Parameterising mode engaged
(for adjustment of E,ALM Hi, ALM Lo)
ALM Hi Temperature high alarm..
ALM Lo Temperature low alarm.
ε
Emissivity coeffi cient.
➄
2-function push-button (*)
Backlit ON/OFF.
Up scroling command for emissivity adjustment or high
and low temperature alarms ALM Hi - ALM Lo (com
mand active if the MODE button was previously activated)
➅
2-function push-buton (*) ::
Laser pointer ON/OFF..
Down scroling command for emissivity adjustment or
high and low temperature alarms ALM Hi - ALM Lo
(command active if the MODE button was previously activated)
➆
MODE push-button (*)
Successive operation push-button for selection of the
specifi c function in the form of a pull-down menu in the
following order :
ε --> ε (SET) --> ALM Hi (SET) --> ALM Lo (SET) --> MAX --> MIN --> K --> ε
(*) For delaited operating mode, see ß 4.2.
7
NU-DX.T10_0906.indd Sec1:13 NU-DX.T10_0906.indd Sec1:13
1 2 3
4
6
5
24/07/2007 14:55:22 24/07/2007 14:55:22
13