HP DesignJet 500 series Aufbauanleitung Seite 2

2. Attach the Stand to the Printer
4–Put the printer onto the stand assembly.
WARNING: 2 people should support the printer while a
third secures the stand—see step 5.
1 cm
1 cm
2–Remove the bin "film" from its container.
will need to form five creases in the film so that it will fit
properly into the bin holders. Four of these creases are
1 cm and 2 cm from each end, both in the same sense,
with an orientation circle on the outside. The third
crease is also in the same sense, and 9 cm from the
end furthest from the orientation circle.
5–...and attach the two caps to this end of the
film.
8–Clip the end pieces to the film and sides.
11–Attach the left adapter to the stand.
marked with the letter 'L', and must be attached to the
front part of the left leg.
If you ever need to remove an adapter, the two latches
near the top must be unclipped; insert a pencil or similar
tool into the hole to release each latch.
(continued)
5–Secure the stand with the four screws that
have large flat heads.
secured normally.
CAUTION: Two of the screws on the same leg will
appear to be not fully tightened, as they will not go in as
far as the others—they should be firm but not over tight.
7 cm
1 cm
1 cm
You
3–Slide the bin "film" into the groove in the bin
holders, and bend it into position.
with the two creases first. Slide the film fully to the end
so that the creases are in the correct positions.
6–Clip the film into place at the other end...
9–The paper bin is now complete.
peel off the orientation circle.
In the next steps it will be attached to the printer stand
by two adapters which must first be located into the
printer legs; then the bin will be slotted into the adapters.
It is
12–Insert the bin onto the adapters.
horizontally and insert the small pins into their slots.
3. Assemble the Paper Bin
Two screws (on one leg) are
1–Insert the four bars into the slots in the right
bin holder, and then mount the left bin holder
onto the four bars.
Insert the end
4–Clip the film into place at one end...
7–...and attach the two caps to this end.
You should now
10–Attach the right adapter to the stand.
marked with the letter 'R', and must be attached to the
front part of the right leg. First hook the bottom into its
slot and then raise it into place; you should hear two
clicks as the top is clipped in.
13–Raise the bin into its correct position.
Hold the bin
Raise the bin until the large pins align with their slots
and the bin drops into place.
Page 2
It is