Bluetooth Unpairing; Manual Upairing Of All Bluetooth Devices - Assa Abloy Cliq Bluetooth-Kopplungsanleitung

Overview
Unpairing by
replacing phones
Manual unpairing
EN
54

Bluetooth unpairing

When using the Mobile PD, there is normally no need to unpair a smart device.
The Mobile PD is discoverable while powered, which allows for a second smart
device to pair with the Mobile PD if it is started and the current smart device is
not present.
The next time the Mobile PD starts up, it will again search for and try to connect
to the first paired smart device. If this search times out, the Mobile PD continues
to search for the second smart device.
If the second smart device is found and the Mobile PD succeeds in setting up a
Bluetooth connection to it, the first smart device is considered to have been
replaced and will be unpaired from the Mobile PD. If the second smart device is
not found, or fails to provide a Bluetooth connection, the Mobile PD does not
forget about the first smart device and will retry to connect at the next startup.
If a pairing initiated from the Mobile PD (using the pair.txt method) is successful,
the new smart device is considered to have been actively chosen and all other
smart devices will be unpaired from the Mobile PD.
For information about the pair.txt method, see "Connecting the Mobile PD to an
iOS device", page 38.
It is possible to unpair all Bluetooth devices from the Mobile PD using a USB
memory stick. Since the Mobile PD firmware supports the smart device replace-
ment method, manual unpair is mainly supported for making the firmware
backwards compatible.

Manual upairing of all Bluetooth devices

1 Create an empty file named unbond and put it in the root folder of a USB
memory stick.
2 Connect the USB memory stick to the Mobile PD using a USB on-the-go cable.
3 Start the Mobile PD.
 You have manually disconnected
devices.
Bluetooth pairing guide (PAN)