Initiate Pairing From The Mobile Pd - Assa Abloy Cliq Bluetooth-Kopplungsanleitung

I
EN
42

Initiate pairing from the Mobile PD

Note!
Error message after unsuccessful search for devices: If the Mobile PD fails to
find the named iPhone, it will time out after about ten seconds and light the red
error LED. If this happens, validate the content of pair.txt and try again.
If no pairing request is shown in the iPhone even after a second try, it is recom-
mended to restart the iPhone and reactivate Bluetooth before trying again.
Once-only pairing of the mobile programming device with the iOS device:
Note that the Bluetooth pairing procedure described here needs to be completed
only once, as long as the iOS device used with the Mobile PD is not replaced.
The pairing process cannot be started from the mobile programming device:
Note that even if the Mobile PD happens to show up in the list of devices on the
iPhone screen during this procedure, pairing cannot be initiated from the iPhone
(the iPhone states that the Mobile PD is not supported and fails to pair).
The red LED can also light up if an action is successful: After successful pairing,
the red error LED may light up. In this case, you can ignore the red LED.
1 Connect the USB memory stick that contains the pair.txt file to the Mobile PD
using a USB on-the-go cable.
2 Make sure that the iPhone screen has not been locked and that the hotspot is
still Discoverable.
3 Place the iPhone close to the Mobile PD.
4 Start the Mobile PD by inserting a key to it.
5 Wait for a confirm pop-up to be shown on the iPhone and then choose Pair.
6 Once paired, disconnect the USB on-the-go cable, the USB memory stick and
the key from the Mobile PD.
 You have started the pairing process from the mobile programming device.
Bluetooth pairing guide (PAN)