Operating Times - Wolf Garten RQ 250 Benutzerhandbuch

Safety instructions
• Be careful when you go backwards. You may stumble!
• Keep the cable away from the cutting tool.
• Should the cable be damaged during use, immediately
disconnect it from the mains. Do not touch the cable until
it has been disconnected from the mains.
• Never leave the trimmer without supervision. Store it
in a safe place.
• The switches installed shall not be removed or bridged
over, e. g. by binding the switch to the handle.
• Do not allow the line spool to strike the ground or
edges of working area. If the line spool receives a
hard knock, this will cause a strong vibration on the
handle. If this occurs, the trimmer should be checked
by a qualified service centre.
fter operating
• fter using the machine, disconnected the cable from
the wall outlet and inspect the unit for damage.
Operation

Operating times

Please convider the individual country
spezification.
How to adjust the central handle (fig. )
The auxiliary handle can be adjusted
sideways and vertically by lossening the
knob. Recommendation: 20 cam from the
upper handle.
Mounting the extension cable (fig. B)
See illustration
Connection to power source
lternating current, 230 V, 50 Hz. The tool
can be connected to any mainssocket.
ttention!
To connect tool to mains use only approved
extension cable (HO7 RN-F3 G1.0).
Working position (fig. C)
The optimal operational gradient for edging
and free-cutting is approx. 30°. For free
cutting (no ground contact) swing device in
a semicircle before your body.
• When switching off the trimmer: ttention: the cutting
mechanism does not stop immediately!
• lways wait for the cutting mechanism is stop.
• Before examining or cleaning the machine or before
removing the safety device or the line, switch off
and disconnect the trimmer from the mains. Only
use original WOLF line and note the installation
instructions!
• The cutting knife should not be cleaned under
running water or under high-pressure.
• Faults shall only be repaired by appointed service
centres or by the manufacturer.
• Make sure all air holes are free of dirt.
• Do not store the unit within reach of children.
Disposal
• Do not dispose of electrical equipment
in domestic waste. Recycle equipment,
accessories and packaging in an environ-
ment-friendly manner.
Vertical edge-trimming (fig. D/E)
Teh machine can be adjusted for vertical
trimming. Grip machine firmly. Pull tube and
turn 180° until it audibly engages.
Thread adjustment (fig. F)
The thread is adjusted with the tilt switch.
Briefly tilt the running machine on a firm
base, e. g. paving slab (approx. 3 kg
pressure). pprox. 2,5 cm cutting thread are
the automatically paid out.
Trimming hints
• Cut tall grass in stages and move the
trimmer slowly.
• Move trimming head only as close to
tree trunks and bushes as necessary.
• Trimming too closely along walls or concrete
slabs wears out line unnecessarily.
• The life of your trimmer will be prolonged
if you clean the ventilating slits before or
after each trimming session and remove
any remaining grass from the bottom of
the device.
• Compost the mowings well or use them
to cover the ground underneath bushes.
13