RTW TM3 Anleitung Seite 91

Horizontal display mode
EN
In order to use the TM3 in horizontal display mode, rotate the display unit
to the left so that the base is positioned on the right hand side.
Wipe across the touchscreen with your finger in horizontal direction to
switch the unit to horizontal display mode and to browse through the
available presets in that mode. Each preset will be presented with its na-
me and a preview illustration of the instruments and display layout used.
Touch the white circled arrow button in the center to load a preset.
To select any other preset, just wipe again.
In order to switch the TM3 back to vertical display mode, just place the
display unit in its upright position again and wipe across the touchscreen
in either horizontal direction to browse through the available presets.
nOTE - Please note that the TM3 recognizes the wipe orientation
(lengthwise or crosswise) in order to switch between vertical and horizon-
tal display modes. It doesn't use a motion sensor for this.
Manual | TM3 3 | Operation | 3.3 | Loading vertical and horizontal Presets EN-23