FALMEC GRUPPO INCASSO 70 Gebrauchsanweisung Seite 22

RADIO CONTROL CODE CHANGE
A default transmission code is factory installed and stored, which is required to transmit controls from the radio control to the hood.
Should electromagnetic interference with other devices cause a radio control malfunction, a new transmission code can be created by following
the procedure indicated in points
1
CREATING A NEW TRANSMISSION CODE
• Disconnect the hood from the electrical mains power supply by unplugging it or by turning off the main switch.
• To access the "code change" mode, simultaneously press the
flashing slowly (approximately 4/5 seconds).
• If, within 5 seconds from when the display starts flashing the radio control
saved: saving is confirmed by three brief flashes of the display. The new code cancels and replaces the previous factory default transmission code.
• Reconnect the hood to the electric power supply, making sure that the lights and motor are off.
2
ASSOCIATING THE RADIO CONTROL WITH THE HOOD
To save the new transmission code created in the hood, press the
after the corresponding red LED has lit up on the push-button control panel, press any key on the radio control within 10 seconds.
RESTORE THE DEFAULT CODE (FACTORY DEFAULT CODE)
• Should it be necessary to restore the default transmission code, disconnect the hood from electric power supply and simultaneously press the
(minus) and (plus) keys on the radio control for more than 5 seconds. This restores the radio control default transmission code factory
setting: three brief flashes on the display are issued as a confirmation that it has been saved.
• Proceed with associating the hood and radio control, as described in point
• Connect the hood to the electric power supply.
USING THE RADIO CONTROL
LIGHTING
The range hood is equipped with high efficiency, low consumption LED spotlights with extremely long duration under
normal use conditions.
Should the LED spotlight need to be replaced, proceed as shown in the figure
(TO BE USED ONLY IN CASE OF MALFUNCTION DUE TO INTERFERENCE)
1 2
and .
Light Button
ON: light on (the
OFF: light off (the
Plus button
Press this key with the motor off (no symbol on the display) to switch the hood on
with speed 1.
If the motor is running, pressing this key increases the motor speed.
Speed 1, 2, 3, and 4 are displayed on the screen by their equivalent symbol number
tor automatically switches to the 3rd speed.
Minus button
Press this key with the motor off (no symbol on the display) to switch the hood motor
on with speed 1 (minimum).
If the motor is running, pressing this key decreases the motor speed.
Speed 1, 2, 3, and 4 are displayed on the screen by their equivalent symbol number
If the motor is running at speed 1, pressing the key switches the hood motor off.
Timer
Pressing the key with the motor active at any speed switches the Timer function on
and off: this function determines the auto switch-off of the hood after 15 minutes
of operation. Activation of this function is signalled by the symbol
on the display. With the Timer function active, the hood can still be switched off by
the user at any time by reducing the speed with the
es off: the function will be automatically disabled and the symbol
will disappear from the display.
(light) and (timer) keys on the radio control until the display starts
(minus) key is pressed, a random transmission code is created and
(timer) key on the push-button control panel of the hood for 2 seconds and,
2
.
symbol is displayed on the screen)
symbol is not displayed)
. The 4th speed or intensive setting is timed and after about 7 minutes the mo-
.
22
key until the motor switch-
M
on page 9.
(Hourglass)
(Hourglass)