Kärcher K 2.54 M Betriebsanleitung Seite 12

Use spray lance with pressure regulation
(Vario Power).
Turn the spray lance to "Mix" position - low
pressure.
DT take-up from container
Pull the required length of the DT suction
hose from the housing.
Place the end the DT suction hose in a con-
tainer with DT solution.
Recommended Cleaning Method
1 Spray a small dose of the detergent on the
dry surface, and allow it to react (make sure
the detergent does not dry up).
2 Wash off the loosened dirt using the high-
pressure jet.
Detergents
To ensure a trouble-free operation of the appli-
ance and to match the individual cleaning task,
we recommend our Kärcher detergent and main-
tenance agents. Please ask for our advice, or re-
quest information on the products.
Cleaning set for two-wheelers
Statutory Provisions
If you clean your vehicle at a washing station that
is not specifically identified please observe the
municipal cleaning provisions.
Proper Use
Use this cleaning kit for the washing and cleaning
of bicycles, such as motorcycles, motor-assisted
bicycles, motor scooters and cycles.
Warning
After the vehicle wash the braking effect is re-
duced due to moisture. Therefore, let the brakes
dry before starting the vehicle.
Spray lance with 2-way nozzle
Low-pressure flat jet
for low-pressure cleaning or for operation
with detergents
High-pressure flat jet
for large areas of dirt
To select the jet type, release the lever on
the handgun and rotate the nozzle head until
the symbol corresponds with the marking on
the spray lance. During operation, this mark-
ing must be facing upwards.
12
English
Cleaning brush
Install the cleaning brush on the handgun of the
high-pressure cleaner.
Note:
Alternatively, the cleaning brush can be used
manually or in combination with a commercially
available supply hose and the Kärcher adapter
for the garden hose connection (hose and adapt-
er are not included in the delivery).
Adapter for garden hose connection (order
no. 2.640-732)
Motorcycle cleaner
Warning
Keep the detergent out of the reach of children.
Do not breathe in the spray.
Application:
Spray the undiluted detergent from a short
distance on the object to be cleaned.
Remove tenacious dirt using the cleaning
brush.
Rinse with the high-pressure water jet.
In case of tenacious dirt the washing effect
can be mechanically increased using the de-
livered cleaning brush.
Recommended Cleaning Method
Note
If the high-pressure jet is directed at vehicle parts
directly or with an insufficient distance damages
may occur.
– Observe a distance of at least 30 cm to coat-
ed surfaces, critical components, such as
bearings, damping parts, electrical compo-
nents, radiator and oil cooler ribs.
– The penetration of moisture at critical com-
ponents and the flushing of grease may re-
sult in functional failures or destruction.
– Never spray the water jet from the side or
from the bottom but only from the top or diag-
onally from the top.
– Grease all critical components requiring oil
or grease again.
Spray the detergent on the vehicle, let the
detergent react and rinse with the water jet.
Remove tenacious dirt using the cleaning
brush.
Use a special detergent for the brake sys-
tem, wheel rims and plastic film.
Use clean leather for drying up. Alternative-
ly: Air emitter with compressor. Observe the
manufacturer's operating instructions!