Transport - Kärcher HD 18/50-4 Cage Classic Originalbetriebsanleitung

The shoulder support (2.639-251.0) should
be used to prevent injuries and to make
work easier at recoil pressures > 150 N.
Power nozzle
The appliance is equipped with the follow-
ing nozzles:
– Power nozzle, 15° spray angle
High pressure flat stream (15°) for large
areas of contamination.
 The working pressure can be read from
the manometer.
Note:
Always direct the high-pressure jet at the
object to be cleaned from a distance to
avoid damage from high pressure.
Interrupting operation
 Release the lever on the trigger gun.
 Use the safety catch to secure the
handgun lever.
 Store the hand spray gun and spray
pipe in the accessory mount.
Changing working pressure
The working pressure can be changed by
using different high-pressure nozzles.
Pressure Nozzle
MPa (bar) size
Flat jet nozzles
50 (500) 15060
35 (350) 15075
25 (250) 15095
15 (150) 15120
Detail nozzles
50 (500) 060
35 (350) 075
25 (250) 095
15 (150) 120
 Select a nozzle from the table above.
 Unscrew the union nut from the spray
lance.
 Replace nozzle.
 Screw on and tighten the union nut.
Note:
This method of pressure adjustment al-
ways means that the full flow rate of 1800 l/
h is always available.
20
Order number
5.765-263.0
2.113-073.0
2.113-075.0
2.113-077.0
5.765-264.0
2.113-074.0
2.113-076.0
2.113-078.0
EN
Finish operation
 Release the lever on the trigger gun.
 Set the appliance switch to "0".
 Shut off water supply.
 Activate hand spray gun until device is
pressure less.
 Use the safety catch to secure the
handgun lever.
 Remove the water inlet hose from the
appliance.
 Pull out the mains plug.
 Stow away the mains cable, the high-
pressure hose and accessory at the ap-
pliance.
Frost protection
WARNING
Risk of damage! Freezing water in the ap-
pliance can destroy parts of the appliance.
Store the appliance in a heated room dur-
ing winter or empty it. During longer breaks
in operation, it is advisable to pump in anti-
frost agents into the appliance.
Drain water
 Screw off water supply hose and high
pressure hose.
 Blow through machine with com-
pressed air.
Flush device with anti-freeze agent
Note:
Observe handling instructions of the anti-
freeze agent manufacturer.
 Pump in conventional frost protection
agents through the appliance.
A certain corrosion protection is achieved
with this as well.

Transport

CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
 Pull the actuation lever of the parking
brake all the way to the back.
– 6
Driving