HASE Sendai Bedienungsanleitung Seite 44

Technical Data Sendai 135/175
The Sendai 135/175, certified in compliance with DIN-EN 13240 and Art. 15 a B-VG
(Austria), can only be operated when the fire box is closed. Conforms with the DIBt
(Deutschen Institut für Bautechnik/German Institute for Building Technology) approv-
al criteria for direct vent fireplaces for solid fuels. Multiple connections to the chim-
ney are possible, see point 4. "Connection of Multiple Devices in Direct Vent
Operation". DIBt approval number: Z-43.12-396 / Typ FC41x and FC51x
The following data applies to the chimney characteristics in accordance with
EN 13384-1 / 2:
Combustion Values*
Nominal Thermal Output
Room heating output
Exhaust gas temperature
Waste Gas Outlet Temp.
Waste Gas Mass Flow Rate
Min. Supply Pressure at Nominal Thermal Output**
Efficiency
CO content at 13% O
2
Particulate
OGC
NO
X
Min. required combustion air volume
* Test bench performance and values at 13% O
Depending on the insulation of the building, the nominal thermal output of 6 kW indi-
cated on 20 - 80 m² (subject to change).
Dimensions: Height
Stove 133/175 - 220 cm
Fire box 61 cm
44
Wood
6
6
236
299
5.33
12
83.5
817
9
66
99
25
2
Width
37 cm
21 cm
Weight Sendai 135
Weight Sendai 175 (without heat retaining block ) / Additional module
Weight 1x heat retaining block flue pipe conection top / rear
¹Vertical flue pipe length
Flue pipe diameter
Pipe diameter of Hase ventilation system**
Front view Sendai 135:
kW
kW
˚C
˚C
g/s
Pa
%
mg/Nm³
mg/Nm³
mg/Nm³
mg/Nm³
37
m³/h
Top view Sendai 135:
Depth
41 cm
27 cm
163 / 15 kg
63 / 52,5 kg
min. 25 cm
Side view Sendai 135:
17,5
Inst. of Hase air system below
Dimensions in cm
** For separate air supply in low-energy houses and
insufficient combustion air supply in the room where
the stove is installed.
140 kg
15 cm
10 cm