5. Setting the parity
is displayed and the
parity can be switched on or off.
: No parity
: Parity
Note
When the data length is set to 7 bits
in step 3, select "Parity".
6. Selecting odd or even parity
Switches to this mode when
is chosen above.
: Odd parity
: Even parity
7. Selecting the function for the RS-TRG terminal
: Mode for inputting
mechanical contact
outputs (such as relay
and switch outputs).
: Mode for inputting
e l e c t r o n i c c i r c u i t
o u t p u t s ( s u c h a s
transistor outputs).
: To output at a set
interval.
Note
The RS-TRG input cannot be used when
18
(E)
8. Selecting the output time interval.
factory-set
9. Selecting the data transmission format
factory-set
factory-set
has been selected.
This mode is selected when
has been chosen in
step 7.
One of the following eight
intervals can be chosen.
0.2/0.5/1.0/5.0/10/30/60/300 s
(2 channel models)
is displayed and one of
the following is chosen.
: format (a) given below
: format (b) given below
• To output from channel A –12.3456, and from
channel B 67.891:
(a) A–12.3456MB
67.8910
+
C R L F
(b) A–12.3456
B
+
Note
M means a space.
factory-set
factory-set
C R L F
C R L F
67.8910
LT20A / LT30 Series