Maintenance; Replace Batteries - Wolf Garten Accu 30 Gebrauchsanweisung

Maintenance

Storage
For storing the rechargeable shears select a
dry place out of the reach of children and insure
that this area is free of frost in the winter.
Cleaning
• Clean the cutter head with a dry cloth after
each trimming.
• The drive should be cleaned and lubricated
at the end of the gardening season (see
„change cutting blades").
ttention!
• Under no circumstances should you
activate the switch while cleaning the
device (figure B, position 2).
• Drive repairs may only be carried out by a
WOLF service facility!
Change Cutter *
1. Remove skid (figure C)
Unscrew screws.
2. Replace cutting head (figure D/E)
Remove the cutting head from the
rechargeable shears. Lubricate the ring
of the cutter with the lubrication tube**
(D) provided, clean the visible area of
the drive, and lubricate this as well with
* For replacement blades see accessories
** Part of the „replacement blade package"
the lubricant provided. Position the ring in
such a way that it is precisely placed over
the eccentric tappet (E).
3. Fastening the skid (figure F)
Fix the screws.

Replace batteries

1. Remove cover (figure G)
Place a coin in the cover slot and press
in the direction of the blade (1). Remove
the cover from above (2).
2. Replace batteries (figure H)
Remove both plugs from the batteries
remove the batteries from the shears.
Place the new batteries in the shears
and connect the two plugs.
3. Fastening the cover (figure J)
Push the lid with the projection (1) under
the edge of the shears and then press
the cover on the shears (2).
Note: Please ensure that no cable
protrudes from
fastening the cover!
the shears when
13