Replacing The Filter Element - Makita 446 L Betriebsanleitung

MAKITA 446 L
english
7.2.3 Replacing the filter
element
5
8 Troubleshooting
Fault
‡ Motor does not start
‡ Motor does not run in auto-
matic mode
10
During the following work,
ensure that dust is not unnec-
essarily spread around.
Wear a P2 breathing mask.
3
2
1
> Fuse in mains plug has
blown.
> Overload protection switch
has tripped.
> Power tool is defective or not
connected properly.
1. Remove the upper section of
2. Turn the filter holder anti-
3. Carefully remove the filter
4. Clean the filter seal (4).
5. Check antistatic clamp (5)
4
6. Check the floater (6) for
7. Fit a new filter element.
8. Fit the filter holder and turn it
6
9. Dispose of the used filter
CAUTION!
Never use the vacuum clean-
er without a filter.
Cause
•
•
•
the cleaner from the dirt tank
and deposit with the filter
element facing upwards. Do
not place the upper section
of the cleaner on the guard
(1).
clockwise (2) and remove it
(3).
element.
Check it for damage and
replace if necessary.
for damage and have it
replaced by Makita Service
if necessary.
proper operation: When
you turn the filter holder, the
floater should move back
and forth easily.
clockwise to secure it.
element in accordance with
legal regulations.
Remedy
Reset the fuse.
Switch off the vacuum
cleaner and allow it to cool
for approx. 5 minutes. If it
can not be started again,
contact the Makita service
department.
Check that the power tool
works or that the plug is
inserted correctly.