Cleaning And Servicing; Storage; Troubleshooting - Bosch MUM 52110 Gebrauchsanleitung

MUM5xxx_de-ar.book Seite 23 Donnerstag, 25. September 2014 9:59 09
After using the appliance
Switch off the appliance with the rotary

switch.
Rotate the blender in a clockwise

direction and remove.
Tip: It is recommended to clean the blender
immediately after use.

Cleaning and servicing

Attention!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
Cleaning the base unit
Risk of electric shock!
Never immerse the base unit in water
or place under running water.
Do not use a steam cleaner.
Remove mains plug.

Wipe the base unit and drive cover with

a damp cloth. If required, use a little
detergent.
Then dry the base unit.

Cleaning the bowl and tools
The bowl and tools are dishwasher-proof.
Do not wedge plastic parts in the dishwasher,
as they could be permanently deformed
during the washing process!
Cleaning the continuous-feed shredder
All parts of the continuous-feed shredder are
dishwasher-proof.
Tip: To remove the red film after processing
e.g. carrots, pour a little cooking oil on a cloth
and rub the film off the continuous-feed
shredder (not the cutting discs). Then rinse
the continuous-feed shredder.
Cleaning the blender
Risk of injury from sharp blades!
Do not touch blender blades with bare
hands.
The blender jug, lid and funnel are
dishwasher-proof.
Robert Bosch Hausgeräte GmbH
Tip: After processing liquids, it is often
sufficient to clean the blender without
removing it from the appliance. Pour a little
water and washing-up liquid into the attached
blender. Switch on the blender for several
seconds (setting M). Pour out the water and
rinse out the blender with clear water.
Important information
If required, clean accessories bag.
Follow care instructions in the bag.

Storage

Risk of injury!
When the appliance is not in use, pull out
the mains plug.
Fig. 
Store tools and cutting discs in the

accessories bag.
Keep accessories bag in the bowl.

To store in the original packaging,

see Fig. .

Troubleshooting

Risk of injury!
Before eliminating a fault, pull out the
mains plug.
Important information for MUM54../
MUM55../MUM56..
The Operating indicator flashes if the
appliance has been operated incorrectly
or the electronic fuse has tripped or the
appliance is defective.
The swivel arm must be engaged in every
operating position.
Initially try to eliminate the problem which has
occurred with the help of the following
information.
Fault
Appliance does not start.
Remedial action
Check the power supply.

Check the mains plug.

en
23