Safety Regulations - EINHELL PH 1800 Originalbetriebsanleitung

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
•
Check that the equipment has been delivered
in perfect condition. If it has suffered any da-
mage, do not connect the equipment to the
power supply.
•
Check the equipment, particularly the mains
cable, for signs of damage every time before
use. If you find signs of damage, contact ISC
GmbH.
•
Position the power cable so that there is no
danger of tripping over it.
•
Do not pass the power cable over hot parts of
the equipment during operation.
•
Never use the power cable to pull the power
plug out of the socket-outlet! Never use the
power cable to carry the equipment or try
to move the equipment by pulling the power
cable.
•
Never wind the power cable around the fan
heater.
•
Never jam the power cable between objects
or pull the cable over sharp edges or position
the cable over hot plates or open flames.
•
Never open the appliance or touch live parts –
danger of fatal accident!
•
Never immerse the equipment in water – dan-
ger of fatal accident!
•
Never use the equipment with wet hands.
•
Position the equipment in such a way that the
power plug is accessible at all times.
•
If the equipment is not used for a lengthy
Anl_PH_1800_SPK7.indb 13 Anl_PH_1800_SPK7.indb 13
GB
period of time, disconnect it from the power
supply.
•
Do not position the equipment directly below
a socket.
•
If the equipment is used for a lengthy time,
the housing can become very hot. Position
the equipment in such a way as to prevent
accidental touching.
•
Do not use the equipment in rooms in which
inflammable materials (for example solvents,
etc.) or gases are used or stored.
•
Keep highly inflammable substances and ga-
ses away from the equipment (min. 4 m).
•
Do not use in areas where there is a fire risk
(for example wooden sheds).
•
Only use the heater with its power lead fully
extended.
•
Not suitable for installation with permanently
installed electrical cables.
•
Do not use the equipment for animal husban-
dry or livestock breeding.
•
Do not insert any foreign objects into the
equipment's openings – danger of electric
shock and damage to the equipment.
•
Keep children and people on medication or
under the influence of alcohol away from the
equipment.
•
Maintenance and repair work may only be
carried out by authorized, trained personnel.
•
When using the appliance in a bathroom, be
sure to observe the safety distances stipula-
ted in your country. It must be impossible for
the control elements to be touched by a per-
son in a shower, in a vessel filled with liquid or
in a bathtub. In Germany the equipment is not
allowed to be operated inside protection zone
0, 1 or 2 in order to comply with VDE 0100
Part 701 (Fig. 10). Please refer to the regulati-
ons in your country.
•
Connect the device to an earthed socket out-
let outside the protection zone only.
•
For electrical safety purposes we recommend
that you install a residual current device
circuit-breaker (RCD).
•
WARNING: This equipment is not equipped
with a device for controlling the room tem-
perature. Unless continuous supervision
is provided, the heater is not allowed to be
used in small rooms which are inhabited by
persons who are unable to leave the room on
their own.
•
Do not move or transport the heater while it is
running or in a hot state. Switch off the heater,
disconnect it from the power supply and allow
it to cool down. Important: The heater will re-
- 13 -
02.03.16 15:14 02.03.16 15:14