Cleaning & Maintenance - Bosch Sensixx DS38i-Temp Gebrauchsanleitung

Accessory code
(After-sales)
00571510
11. Calc'nClean Perfect
Automatic clean warning
The "Calc" automatic clean warning indicator light
(4) will flash indicating that boiler and iron steam
chamber must be rinsed.
Leave the appliance unplugged for more than two
hours, check carefully that the appliance is cold
and that the water tank (1) is empty.
Please proceed as follows:
11.1 Cleaning the Boiler

See the leaflet sides
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
1 Fix the iron to the stand by inserting the tip of
the iron into the front slot and moving the lock
system (3) against the heel of the iron. Place
your appliance on the edge of your kitchen sink.
2 Unscrew the scale collector (12*) and take it
out.
3 To wash the scale collector, place it under the
water tap and wash it up until calc residues are
removed. Squeeze it as indicated in the picture
a).
To obtain the best result, you may immerse the
scale collector for approximately 30 minutes in
tap water (250 ml) mixed with a measure
(25 ml) of descaling fluid, as indicated in the
picture b).
Then, rinse it again with water (very
important!).
The descaling fluid can be obtained from our
Aftersales Service or Specialist outlets:
Accessory code
(After-sales)
00311715
4 Holding your steam generator in upside down
position, and using a jug, fill the boiler (in the
base unit) with 1/4 litre of water.
5 Shake the base unit for a few moments and
then empty it completely over a sink or bucket.
20
B O SC H
Name of accessory
(online shop)
TDZ2045
Name of accessory
(Specialist outlets)
TDZ1101
To obtain the best result, we recommend that
this operation is performed twice.
Important: before re-closing, make sure no
water remains in the boiler.
6 Replace and tighten up the scale collector.
11.2. Rinsing the iron steam
chamber

See the leaflet sides
1 Fill the tank with tap water.
2 Plug in the mains cable and set the power
button (10) to the "I" position.
3 By turning the programme selector (9), choose
"Calc'nClean" decalcification programme. The
indicator light (7) will start flashing.
4 Wait until the indicator light (8) stops flashing
and remains lit continuously. Two beeps will be
heard at the same time.
5 Hold the iron over the sink or a container to
collect the water.
6 Press the steam release button (14) and gently
shake the iron. Boiling water and steam will be
released, carrying scale and/or deposits that
might be inside.
After approximately one minute, the "Calc"
automatic clean warning indicator light (4) will
go off.
Keep on shaking the iron gently for five
minutes while the steam release button is
pressed, so that water and steam clean the
chamber completely.
7 Without pressing the steam release button
(14), turn the programme selector (9) and
choose "Linen / max" programme. The water in
the steam chamber will start evaporating.
8 Wait until all the water inside the chamber has
been evaporated. Then, you can set the power
button (10) to the "O" position.
9 To clean the soleplate, immediately rub off any
residue by running the hot iron over a wet
cotton cloth.
12. Cleaning & Maintenance

See the leaflet sides
E
Attention! Risk of burns!
Always unplug the appliance from the
mains supply before carrying out any
cleaning or maintenance operation on it.
* Model dependent