Storing The Appliance; Troubleshooting - Bosch Sensixx DS38i-Temp Gebrauchsanleitung

1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cotton cloth.
3. If the soleplate is soiled with dirt or scale, clean
it with a damp cotton cloth.
4. If the cloth is synthetic, it may melt due to the
high temperature on the soleplate. Switch off
the steam and rub off any residue immediately
with a thickly folded, damp cotton cloth.
5. Never use abrasive products or solvents. To
keep the soleplate smooth, you should avoid
hard contact with metal objects. Never use
a scouring pad, or chemicals to clean the
soleplate.

13. Storing the appliance


See the leaflet sides
1. Set the power button to the "O" position and
disconnect the mains cable.
2. Always allow the appliance to cool down before
storing it.
3. Place the iron on the iron pad (2), standing on
the soleplate, and fix it by inserting the tip of
Trouble shooting
Problem
The "Calc" indicator light
(4) flashes.
The ironing programme
indicator light (7) flashes
continuously.
The steam generator
does not come on.
The iron does not heat
up.
The iron begins to smoke
when switched on.
* Model dependent
Possible causes
1. Boiler and iron must be rinsed.
1. The water tank (1) is empty.
1. There is a connection problem.
2. The power button is not switched
on.
1. The power button is not switched
on.
2. The temperature is set to a low
position.
1. During first use: certain
components on the appliance
have been lightly greased at the
factory and may produce a little
smoke when initially heated.
2. During subsequent use: the
soleplate may be soiled.
the iron into the front slot and moving the lock
system (3) against the heel of the iron.
4. Empty the water tank, store the mains cable on
the cord storage facility and the steam hose in
the storage fixing. Do not wrap the cords too
tight.
5. Hold the iron´s handle when moving the
appliance.
Tips to help you save energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
• Start by ironing the fabrics that require
the lowest ironing temperature. Check the
recommended ironing temperature on the label
on the garment.
• Try to iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the iron.
• If you tumble dry your fabrics before ironing
them, set the tumble drier on the 'iron dry'
programme.
Solution
1. Rinse the boiler and the iron according to
the cleaning instructions in this manual.
1. Fill the water tank.
1. Check the mains cable (13), the plug and
the socket.
2. Set the power button (10) to the "I"
position.
1. Set the power button (10) to the "I"
position.
2. Set the temperature to the desired
position.
1. This is completely normal and will stop
after a short while.
2. Clean the soleplate according to the
cleaning instructions in this manual.
21
BOS CH