Starting Operation - Bosch IXO Originalbetriebsanleitung

OBJ_BUCH-3324-001.book Page 33 Tuesday, September 26, 2017 9:42 AM
English | 33
Assembly (see figures C–D)
For assembly of the attachments, pull the rubber cap 3 off toward the front.
Afterwards the attachments can be mounted. The attachments can be
mounted offset by 45°.
Dismounting (see figures E–F)
To dismount the attachments, turn the release ring 20 in rotation direction
 and pull the attachment off toward the front. Afterwards, mount the rub-
ber cap 3 again.
Operation

Starting Operation

Reversing the rotational direction
The rotational direction switch 5 is used to reverse the rotational direction of
the machine. However, this is not possible with the On/Off switch 7 actuat-
ed.
 Do not use the rotational direction switch 5 when the power tool is in
operation, as this may damage it.
Right rotation: To drive in screws, slide the rotational direction switch 5 for-
ward to the stop.
Left rotation: To loosen or unscrew screws, slide the rotational direction
switch 5 to the back.
Switching On and Off
To start the machine, press the On/Off switch 7 and keep it pressed.
The work light 10 illuminates when the On/Off switch 7 is lightly or fully
pressed and allows the illumination of the work area in poor lighting condi-
tions.
To switch off the machine, release the On/Off switch 7.
To save energy, only switch the power tool on when using it.
Bosch Power Tools 1 609 92A 43H | (26.9.17)