Starting Operation - Bosch WEU PSR 7,2 LI Originalbetriebsanleitung

OBJ_BUCH-781-005.book Page 28 Monday, July 8, 2013 6:00 PM
28 | English
The power tool cannot be used during the charge procedure; it is not defec-
tive when inoperative during the charging procedure.
Observe the notes for disposal.
Changing the Tool (see figure B)
 Do not use double-sided screwdriver blades that are longer than
25 mm.
Insert the screwdriver bit 1 directly into the tool holder 2.
Operation

Starting Operation

Reversing the rotational direction (see figure C)
The rotational direction switch 9 is used to reverse the rotational direction of
the machine. However, this is not possible with the On/Off switch 8 actuat-
ed.
Right rotation: For driving in screws, push the rotational direction switch 9
left to the stop.
The indicator for right rotation 4 lights up when the On/Off switch 8
is actuated and the motor is running.
Left Rotation: For loosening or unscrewing screws, push the rotational di-
rection switch 9 right to the stop.
The indicator for left rotation 6 lights up when the On/Off switch 8
is actuated and the motor is running.
Setting the torque
With the torque preselection ring 3, the required torque can be preselected
in 10 steps. The inserted tool is stopped as soon as the set torque is reached.
Position 1:
Lower torque for screwing in screws with small diameter or into soft materials.
Position 10:
Higher torque for screwing in screws with large diameter or into hard materials.
Switching On and Off
To start the machine, press the On/Off switch 8 and keep it pressed.
1 609 92A 0A9 | (8.7.13) Bosch Power Tools