Service And Operation; Led Display Anode And Service; Cleaning; Customer Service - Bosch TR5500T Montage- Und Gebrauchsanweisung

9

Service and Operation

The hot water temperature may be set
the dial. We recommend the setting of 60 °C. Heat wastage and
calcification are lowest here.
As hot water is extracted the amount of hot water available in
the reservoir decreases. The less hot water available, the fewer LEDs
are lit up.
The heating period is dependent upon the volume of water in the reservoir,
the cold water intake temperature, and the set heat output.
See technical data table (page 12)
The hot water storage unit may be used optionally for
closed (pressurised) operation
suitable for service of multiple tapping points
open (de-pressurised) operation
suitable for service of one tapping point
There are three variations of electrical connections to choose from:
Single-power operation
Reheating occurs automatically subject to the power supply.
The button "fast-heating"
and diagnostic routine functions (technician).
Double-power operation
During off-peak periods, the hot water storage unit
automatically heats the contents of the reservoir at
the configured basic performance. The quick heating may be
activated by pressing the fast-heating button
As the device is heating up the LED
out again as soon as the set temperature is reached. The "fast-
heating" switches itself off automatically.
Boiler mode operation
In this mode the hot water storage unit heats the contents of
the reservoir once upon the initial operation at the connected
and configured basic performance. Each further heating proce-
dure must be started manually by pressing the button fast-
heating .
10

LED display anode and service

In normal operations, the LED "anode"
the LED "service" is off.
If these conditions are not respected an "error condition" occurs.
To begin with, please reset the device
as follows:
Firstly turn the dial to the setting "●".
After that, press the "fast-heating" button
If the cause of the error condition does not exist directly after the reset,
the device will again return to its normal mode of function. Otherwise
the device will again indicate an "error condition".
In this case please contact the customer service operator.
TR5500T – 6 720 875 994 (2017/12)
between * and 85 °C using
is only used for the reset
.
lights up, before going
is constantly lit,
RESET. To do this, proceed
.
11

Cleaning

• Wipe with a damp cloth. Do not use any sharp or coarse cleaning
products.
• Do not use a steam cleaner.
12

Customer Service

In order to avoid hazards, repairs may only be carried out by
a customer service operator licensed by us.
The initial service through our customer service operator should take place
around two years after the first operation. At this time, the device will
potentially be decalcified. Afterwards, the customer service operator will
recommended a date for the next service. Specify the E-No. and FD-No.
when phoning the customer service operator!
When requesting customer service, please enter the E-No. and
the FD-No. of your device.
You will find the numbers on identification plate between the water
access pipes of the reservoir.
E-Nr.
13

Disposal

This appliance is labelled in accordance with European
Directive 2012/19/EU concerning used electrical and
electronic appliances (waste electrical and electronic
equipment – WEEE). The guideline determines the framework
for the return and recycling of used appliances as applicable
throughout the EU.
Please ask your specialist retaller about current disposal
facilities.
Service and Operation
FD
Subject to change.
15