Commissioning - Wellsystem WELLSYSTEM_SPA Gebrauchsanweisung

11/2015 1010400-04A
There are two SD card slots behind the AROMA canister.
– Insert the SD card into one of the two slots with the rear end to the front.
NOTE:
Only one SD card can be used at any time.
The assembly is the same process in reverse order.
– Replace and close the cover.
2.3

Commissioning

WARNING!
Damage to device possible!
Where there are great differences in temperature between
the transport route and the installation site the device may
not be put into operation immediately after being set up.
– Wait at least 2 hours before connecting the device to
the power supply.
– Plug in the device's power plug.
– Set the switch on the rear side of the device to I.
The device is ready for operation.
Assembly / commissioning
Operating instructions – 21/48