Conrad VC 350E Bedienungsanleitung Seite 20

e) To run the PC program, click on "OFF" in the bottom right of
the menu box.
Step 3
Use of MS DOS software is described below:
a) Switch on the computer and measuring instrument. The MS
DOS program is named METER.
Note
The following installation(s) presuppose basic knowledge of the
various MS DOS commands and an available hard disk. If in-ade-
quate or no basic knowledge of MS DOS commands is available,
refer to the MS DOS manual concerning software installation. In
addition, a VGA monitor (+ VGA card in the computer) is required
to operate the software.
1. Insert the floppy disk into the appropriate disk drive (A or B or
similar).
2. Make a directory on the hard disk (usually "C") with the name
"METER".
cd\ [Enter]
md METER [ENTER] [ENTER] = Press the "Enter" key.
3. Change to drive A (or B, etc., according to the installation). Call
the file METER and press ENTER key, e.g.:
cd METER
4. Copy the files from the floppy to the hard disk:
copy a:\DOS c:
5. In order to start the program, enter "DMM" and press "Enter".
After that, follow the on-screen instructions.
38
Notes
Should there be no hard disk available, it is possible to start
the program from the floppy disk: Change to the drive in
which the floppy will be run.
Change to the "DOS" subdirectory on the floppy, type "DMM"
and press Enter.
To stop the program, or if an "ERROR" occurs, perform a warm
boot (Control, Alt, Del keys).
Step 4
The following defines the communication parameters.
Transfer rate : 1200 baud
Character code : 8-bit ASCII
Parity : none
Stop bits : 1
Step 5
The configuration of the measuring instrument interface is as
follows:
RS-232C
RXD
GND
TXD
DSR
RTS
Data transfer between the measuring instrument and the
computer is bi-directional.
39