Replacing The Lamp; Closing The Door - AEG Electrolux SANTO Z 9 18 02-4i Benutzerinformation

Problem
Temperature cannot be
set .
The temperature in the
appliance is too low/high.
The temperature in the
refrigerator is too high.

Replacing the lamp

1. Switch off the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of the
arrow.
3. Replace the lamp with one of the same
power (the maximum power is shown on
the lamp cover).
4. Install the lamp cover by sliding it into its
original position.
5. Switch on the appliance.
6. Open the door. Make sure that the light
comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Force Center.
Possible cause
TURBO COOLMATIC function
switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
What to do if...
Solution
Switch off TURBO COOLMATIC
manually, or wait to set the tem-
perature until the function has
reset automatically. Refer to
"TURBO COOLMATIC function"..
Set a higher/lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
51