Switching On The Fridge; Switching Off The Fridge; Temperature Setting Buttons; Temperature Indicator - AEG Electrolux SANTO Z 9 18 02-4i Benutzerinformation

Switching on the fridge

1. Insert the plug into the mains socket.
2. Press ON/OFF switch .
3. The Pilot Light will light up.

Switching off the fridge

1. Keep ON/OFF switch pressed for more than 5 seconds.
2. After that, a countdown of the temperature from -3 -2 -1 will be shown. When "1"
appears the fridge is turned off. The temperature indicator switches off. The Pilot light
switches off.

Temperature setting buttons

The temperature is adjusted using the temperature setting buttons. These buttons are con-
nected to the temperature indicator.
• The temperature indicator is switched over from the indicator of the ACTUAL tempera-
ture (Temperature indicator is illuminated) to the indicator of the DESIRED temperature
(Temperature indicator flashes) by pressing one of the Temperature setting buttons.
• Each time one of the two buttons is pressed again the DESIRED temperature is adjusted
by 1°C. The DESIRED temperature must be reached within 24 hours.
If neither button is pressed, the temperature indicator automatically switches back after a
short period (approx. 5 sec.) to the indicator of the ACTUAL temperature.
DESIRED temperature means:
The temperature that has been selected for inside the fridge. The DESIRED temperature is
indicated by flashing numbers.
ACTUAL temperature means:
The temperature indicator shows the current temperature inside the fridge. The ACTUAL
temperature is indicated with illuminated numbers.

Temperature indicator

The temperature indicator shows several information:
• During normal operation, the temperature currently present in the fridge (ACTUAL tem-
perature) is displayed.
• When the temperature is being adjusted a flashing display indicates the fridge temper-
ature currently set (DESIRED temperature).
When changing the temperature setting wait about 24 hours until the temperature display
has stabilised.

Temperature regulation

To operate the appliance, proceed as follows:
1. Set the required temperature by pressing the corresponding temperature regulator. The
temperature indicator will immediately show the changed setting (DESIRED tempera-
ture) and the temperature indicator flashes.
2. Each time the temperature regulator is pressed the DESIRED temperature is adjusted
by 1 °C. The DESIRED temperature must be reached within 24 hours.
3. Once the required temperature has been set, after a short period (approx. 5 sec.) the
temperature indicator will show again the current ACTUAL temperature inside the cor-
41
Control panel