Switching Off; Temperature Indicator; Temperature Regulation; Turbo Coolmatic Function - AEG Electrolux SANTO Z 9 12 40-6i Benutzerinformation

6
Control panel

Switching off

1. Keep ON/OFF switch pressed for more than 5 seconds.
2. After that, a countdown of the temperature from -3 -2 -1 will be shown. When "1"
appears the appliance is turned off. The temperature indicator switches off. The Pilot
light switches off.

Temperature indicator

The temperature indicator shows several information:
• During normal operation, the temperature indicator shows the current temperature in-
side the fridge (ACTUAL temperature). The ACTUAL temperature is indicated with illumi-
nated numbers.
• During temperature adjusting operation, the temperature indicator shows the fridge
temperature currently set (DESIRED temperature). The DESIRED temperature is indicated
by flashing numbers.

Temperature regulation

To operate the appliance, proceed as follows:
1. Set the required temperature by pressing the corresponding temperature regulator. The
temperature indicator will immediately show the changed setting (DESIRED tempera-
ture) and the temperature indicator flashes.
2. Each time the temperature regulator is pressed the DESIRED temperature is adjusted by
1 °C. The DESIRED temperature must be reached within 24 hours.
3. Once the required temperature has been set, after a short period (approx. 5 sec.) the
temperature indicator will show again the current ACTUAL temperature inside the cor-
responding compartment. The temperature indicator will change from flashing to con-
tinuous illumination.
For a correct storage of the food the following temperature should be set:
• +5 °C in the fridge
When the setting is changed, the compressor does not start immediately if automatic de-
frosting is currently taking place. As the storage temperature within the fridge is reached
quickly you can store food immediately after switching on.

TURBO COOLMATIC function

The TURBO COOLMATIC function is suited for quick cooling of large quantities of goods in
the refrigerator.
To activate the function, do these steps:
1. Press the TURBO COOLMATIC button.
2. The TURBO COOLMATIC indicator switches on.
The TURBO COOLMATIC function now provides for intensive cooling. A DESIRED tempera-
ture of +3°C is automatically selected.
The TURBO COOLMATIC function is ended automatically after a period of 6 hours.
You can deactivate the function at any time:
1. Press the TURBO COOLMATIC button.
2. The TURBO COOLMATIC indicator switches off.