Service; Environment Protection; Control Panel; Switching On - AEG Electrolux SANTO Z 9 12 40-6i Benutzerinformation

• The appliance must not be located close to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of the appliance.
• Connect to potable water supply only.

Service

• Any electrical work required to do the servicing of the appliance should be carried out by
a qualified electrician or competent person.
• This product must be serviced by an authorized Service Centre, and only genuine spare
parts must be used.

Environment Protection

This appliance does not contain gasses which could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The appliance shall not be discarded together
with the urban refuse and rubbish. The insulation foam contains flammable gases: the ap-
pliance shall be disposed according to the applicable regulations to obtain from your local
authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the symbol

CONTROL PANEL

1 2
1. Pilot light
2. ON/OFF switch
3. Temperature regulator (warmest)
4. Temperature indicator
5. Temperature regulator (coldest)
6. FROSTMATIC indicator
7. FROSTMATIC switch
8. TURBOCOOLMATIC indicator
9. TURBOCOOLMATIC switch
The TURBOCOOLMATIC and FROSTMATIC functions cannot be switched on simultaneously.

Switching on

1. Plug the mains plug into the mains socket.
2. Press ON/OFF switch.
3. The pilot light will light up.
4) If a water connection is foreseen.
4)
3 4
are recyclable.
5 6 7 8 9
5
Control panel