Operating Elements - VOLTCRAFT MS-258 II Bedienungsanleitung

Operating elements

(1) Metal sensor (4)Detector for start of test
(2) Optical indicator (LED) (5)Battery compartment (below shirt clip)
(3) Sensitivity controller (6)AC Volt sensor
(7)Continuity - Test - PIN
Inserting the battery/changing the battery
For operation the Multitester needs two round cells of type LR44 or
equivalent types, such as SR44 or V13AG.
Proceed as follows to replace the batteries:
- Turn the shirt clip to the left by 90° to make the battery compart-
ment visible.
- Open the lid of the battery compartment and remove the two dis-
charged batteries.
- Replace them by two new one of type LR-44 or equivalent.
Observe the polarity (see illustration or imprint in the lid of the bat-
tery compartment).
- Place the lid of the battery compartment on the device, and close
the battery compartment by turning the shirt clip to right by 90°.
14
In order to prevent an electric shock, the device must
not be operated in open condition. After every change
of battery, a self-test has to be carried out.
Do not leave batteries lying around. Children or pets
may swallow them. Leaking or damaged batteries may
cause injuries when in contact with skin. Never try to
charge batteries. Do not throw batteries into the fire.
Environmental note!
In Germany the end user is legally obliged to return all used batter-
ies (including round cells and lead-acid batteries). Disposal in
household waste is not permitted.
You may return used batteries, free of charge, to one of our branch-
es, to the head office in Hirschau or, as usual, to municipal waste
disposal sites (re-cycling depots), which are obliged to accept them.
Make your own contribution to environmental protection!
Self-test
Prior to every use the device has to be checked for correct function
in a self-test. Prior to every use, check the device for damage, such
as broken housing, et cetera.
Self-test of the voltage sensor:
Turn the sensitivity controller (3) to minimum sensitivity (anti-clock-
wise to stop) and press the button for start of test (4). Rub the volt-
age sensor (6) on your shirt sleeve or on your trousers. A short illu-
mination of the LED (2) and an acoustic signal indicate the correct
function of the device. If no optical or acoustic signal occurs, the
device must not be put into operation.
15