Ventilation Requirements; Installing The Appliance - AEG SANTO K 7 10 03-6i Benutzerinformation

1. Loosen and remove the upper pin.
2. Remove the door.
3. Remove the spacer.
4. With a key, loosen the lower pin.
On the opposite side:
1. Tighten the lower pin.
2. Install the spacer.
3. Install the door.
4. Tighten the upper pin.

Ventilation requirements

The airflow behind the appliance must be suffi-
cient.

Installing the appliance

CAUTION!
Make sure that the mains cable can move freely.
Do the following steps:
Installation
min.
50 mm
200 cm
2
29
min.
200 cm
2